Error Management

The Error Management window identifies and (where possible) corrects logical errors that may arise during project design.

Tabs

Errors: Lists all detected project errors with columns for No., Description, Page, and Coordinate.
Settings: Select which error types to display. Use Check all or Uncheck all for bulk selection.

Allows you to collectively change or correct errors on selected lines based on common element properties.

No.	Description
1	Potential-arrow pair in wrong direction
2	Cable for not allowed type or shielding
3	Cable with not enough conductors
4	Too many entries for terminal plan area
5	Contact without a main element
6	Not defined connector
7	Terminal strip name not defined
8	Terminal used too many times
9	Cable conductors not suitable for PE/N
10	Connection designations missing
11	Cable shielding ends not connected to PE or Ground
12	Contactor without any used contacts
13	PE/N terminal not connected to PE
14	Duplicate designation
15	Wrong symbol type for socket
16	One/two ends of terminal not used
17	Unused cable conductors
18	Parts without price
19	Terminal jumping without predefined jumper property
20	Jumping between terminals of different strips
21	Missing pair of potential-arrow
22	Device without part
23	Plug has not enough contacts/pins
24	Cable has more than one PE/N conductor
25	Cable has total shielding only, not for conductors
26	Cable can have only 1 PE conductor
27	Cable can have only 1 N conductor
28	Cable can have only 1 SH conductor
29	Unused conductors on the cable
30	Terminal does not match conductor of cable (PE terminal to PE)
31	Shielding cannot be connected to SH in a cable
32	Cable type and used conductors do not match
33	Duplicate connection designation
34	Same terminal number used more than once
35	More than one shielding
36	Motor-protection-relay without contacts
37	Potential-arrow pair not found
38	Contactor not current — used and available contacts differ
39	Used symbol does not match contactor's cross-referenceable contacts